Garage door won't close: sensor repair in Bernardsville

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (908) 888-9325

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Bernardsville, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Belt-drive garage door opener on the ceiling rail

Doors that won't close in Bernardsville

On Bernardsville Mountain, Gilded Age estates and later large homes sit on steep, wooded land with long driveways, and garages and carriage houses there see leaves, runoff and wildlife in quantity. Multi-bay garages mean several pairs of sensors, and the idle bay's pair is the one that fails unnoticed. In the village around Olcott Square and the Olcott Avenue district, older houses have detached garages on smaller lots. In Little Italy, compact houses have tight garages. On the Mine Brook side, low ground is damp. Frost heave on the mountain also shifts slabs and leaves sensors mismatched in height.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Bernardsville

  • Bernardsville Mountain: Gilded Age estates with carriage houses, stables and long drives.
  • Mine Brook side: Streets toward Mine Brook Road with mid-century homes.

See the full Bernardsville service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (908) 888-9325
Call (908) 888-9325